Bender NGRM700 - Page 5

Table of Contents
5
NGRM7xx_D00292_07_M_XXEN/02.2022
7.3 Changing settings ........................................................................................... 39
7.4 Data measured values (menu 1) ................................................................ 40
7.5 Harmonics (menu 2) ....................................................................................... 41
7.6 History (menu 3) .............................................................................................. 41
7.7 Pulser (menu 4) ................................................................................................ 42
7.8 Display (menu 5) .............................................................................................. 42
7.9 HRG, LRG settings (menu 6) ......................................................................... 43
7.9.1 HRG, LRG system (menu 6.1) ....................................................................... 43
7.9.2 CT (menu 6.2) .................................................................................................... 43
7.9.3 NGR (menu 6.3) ................................................................................................ 44
7.9.4 Phase monitor (menu 6.4) ............................................................................ 45
7.9.5 Response values (menu 6.5) ........................................................................ 45
7.9.6 System settings (menu 6.6) .......................................................................... 49
7.9.7 Field calibration (menu 6.7) ......................................................................... 50
7.10 Device settings (menu 7) .............................................................................. 51
7.11 Commissioning (menu 8) ............................................................................. 55
7.12 Info (menu 9) ..................................................................................................... 56
7.13 Alarm (menu 10) .............................................................................................. 56
8. Initial commissioning .......................................................................... 57
8.1 Response values ............................................................................................... 57
8.2 Output relays operating modes ................................................................. 58
8.2.1 Field calibration ............................................................................................... 58
8.2.2 Trip times ............................................................................................................ 58
8.3 RMS trip signal, fundamental, harmonics ............................................... 61
8.4 Initial measurement ....................................................................................... 61
9. Analogue and digital I/O configuration ........................................... 63
9.1 Analogue output (menu 6.6.4) ................................................................... 63
9.2 Digital outputs (Q1, Q2) ................................................................................ 63
9.2.1 Use of Q1: Device health ............................................................................... 64
9.2.2 Use of Q2: Pulser ............................................................................................. 64
9.3 Digital input ....................................................................................................... 64