Benelli 502C - Adjusting the Headlight Beams

3 - 15
Instrument and control functions
EN
3
Rear shock absorber
The vehicle is equipped with a rear shock
absorber.
ATTENZIONE
To avoid damaging the mechanism, do
not attempt to turn over the maximum
or minimum setting.
Always entrust the assistance of the
shock to a Benelli authorized dealer.
Adjusting the headlight beams
The headlight beam adjusting screw is
used to raise or lower the height of the
headlight beams. It may be necessary to
adjust the headlight beams to increase
visibility and help prevent blinding onco-
ming drivers when carrying more or less
load than usual.
Obey local laws and regulations when
adjusting the headlights.
To raise the light beams, turn the screw
clockwise (A).
To lower the light beams, turn the screw
counter-clockwise (B).
A
B