6 - 17
Periodic maintenance and adjustment
EN
6
WARNING
Never overload your vehicle. Operation
of an overloaded vehicle could cause
an accident
Tire inspection
1. Tire tread depth
2. Side well
3. Wear warning
The tires must be checked before each
ride. If the center tread depth reaches
the specied limit, if the tire has a nail or
glass fragments in it, or if the sidewall is
cracked, have a Benellidealer replace the
tire immediately.
TIP
The tire tread depth limits may dier from
country to country. Always comply with
the local regulations.
WARNING
• Have a Benelli dealer replace
excessively worn tires. Besides
being illegal, operating the vehi-
cle with excessively worn tires
decreases riding stability and can
lead to loss of control.
• The replacement of all wheel and
brake related parts, including the
tires, should be left to a Benelli
dealer, who has the necessary pro-
fessional knowledge and expe-
rience to do so.
• Ride at moderate speeds after
changing a tire since the tire sur-
face must rst be “broken in” for it
to develop its optimal characteri-
stics.
Tires age, even if they have not been used
or have only been used occasionally.
Cracking of the tread and sidewall rubber,
sometimes accompanied by carcass de-
formation, is an evidence of ageing. Old
B
A
C
1
Minimum tire tread depth
(front and rear):
1.6 mm
Tire air pressure
(measured on cold tires):
Front: 220 ± 10 kPa
Rear: 250 ± 10 kPa
*Maximum load*:
190 Kg
* Total weight of rider, passenger, cargo
and accessories
2
3
To Next Page
Loading...
Need help?
General
