28
Turning the projector on or off
Once the projector is correctly located and the power cable and other connections are in place, it
is important that the projector is connected and powered on correctly in order to avoid possible
dangers such as electric shock and re. Refer to the following guide to power on the projector.
1. Turn the main power switch to
ON
, Power light is red after power has been applied.
2. Press the
POWER
button on the projector or
ON
button on the remote control to start the
projector. The Power and Lamp LED ashes green and the cooling fan start operating.
3. The projected image will be displayed on the screen for a few second while it is warming up.
4. Once the power LED is lit a solid green, the projector is ready for use.
5. If any of the LEDs remain ashing or blink there may be a problem with the start up. Please
refer to “Troubleshooting” on page 58.
If you attempt to re-start the projector shortly after shutdown, the fans may run for a few minutes to cool down. Press
Power
again to start the projector after the fans stop and the Power indicator light turns orange.
To Next Page
Loading...
