BenQ PX9510 - Selecting Input Sources

English
29
Selecting an input source
The projector can be connected to multiple equipment at the same time. When the projector
is rst turned on, it will attempt to reconnect with the input source which was in use when the
projector was last shut down.
To select the video source
The input source can be selected from the projector's control panel or from the remote control.
Refer to the following guide to select the desired input source.
1. Press
INPUT
key on the remote control or control panel to display
Source
menu.
2. Select your desired input source via
▲
/
▼
key.
3. Press
ENTER
key to conrm the source, it will take few seconds to detect the desired input
signal and display the projected image.
Press
RETURN
key to projected image if you want to keep current input source.
If you want the projector to automatically search for the signals, select
On
in the
Signal
>
Auto Search
menu.