43
Custom Power Level
Press
◄►
arrow key to customize lamp output power in the range of 75-100% of normal
mode. This function is valid only when the
Custom Power Level
option is set to
Custom
Power Level
mode. In the other two modes,
Normal
and
ECO
, this function is disabled
(dimmed).
Digital Alignment
Select this function to zoom the projection image.
Digital Zoom
: Press
◄►
arrow key to zoom in the projection image.
Digital Pan
: Press
◄►
arrow key to pan out on projection image. This is valid only when the
projected image is enlarged.
Digital Scan
: Press
◄►
arrow key to tilt projection image. This is valid only when the
projected image is enlarged.
Reset
: Press to reset
Digital Alignment
settings to factory default values.
H/V Alignment
H Zoom
: Use
◄►
to narrow the horizontal size of the projected image.
V Zoom
: Use
◄►
to narrow the vertical size of the projected image.
H Shift
: Use
◄►
to move the narrowed projected image horizontally. This function is only
available when the projected image is narrowed.
V Shift
: Use
◄►
to move the narrowed projected image vertically. This function is only
available when the projected image is narrowed.
Reset
: Set the
H/V Alignment
back to the factory default settings.
3D
Set up 3D format and sync method. The projector displays options available for setup by
detecting connected input signal type and dims these unavailable items. Please ensure you have
connected to input signal before 3D setup.
3D Format
Select this option and press the
Enter
button to enable 3D playback and set 3D options.
Off
: Turn off the 3D Display Mode and press the
Enter
button..
Note when
Auto
,
Side by Side
,
Top/Bottom
or
Frame Sequential
is selected, the 3D mode
will be turned on automatically.
Auto
: Enable the 3D format detection such as
Side by Side
,
Top/Bottom
and
Frame
Sequential
. This function may only be enabled for the input signal below:
• The input signal is HDMI 1.4 3D.
• The HDMI 1.4 3D signal connects to the projector through HDBaseT transmitter.
Side by Side
: Manually switch the 3D Format to Side by Side. This option is only applicable
to the HDMI input signal, the signal can be sent from the HDMI output of media device or
through HDBaseT transmitter.
Top/Bottom
: Manually switch the 3D Format to Top/Bottom. This option is only applicable
to the HDMI input signal, the signal can be sent from the HDMI output of media device or
through HDBaseT transmitter.
Frame Sequential
: Set the format to Frame Sequential.
To Next Page
