4920-
9840
feet
5. Do not block the vents holes while the
projector is on (even in standby mode):
- Do not cover the projector with any item.
- Do not place the projector on a blanket,
bedding or any other soft surface.
6. In areas where the mains power supply
voltage may uctuate by ±10 volts, it is
recommended that you connect your
projector through a power stabilizer, surge
protector or uninterruptible power supply
(UPS) as appropriate to your situation.
UPS
7. Do not step on the projector or place any
objects upon it.
8. Do not place liquids near or on the
projector. Liquids spilled into the projector
will void your warranty. If the projector
does become wet, disconnect it from the
power point and call BenQ to have the
projector repaired.
9. Do not look straight into the projector lens
during operation. It may harm your sight.
10. Do not operate the projector lamp beyond
the rated lamp life. Excessive operation of
lamps beyond the rated life could cause a
lamp to break on rare occasions.
!!
11. The lamp becomes extremely hot during
operation. Allow the projector to cool for
approximately 45 minutes prior to removing
the lamp assembly for replacement.
!!
To Next Page
Loading...
