Inserting a bobbin/Threading lower thread
⦁
insert the bobbin so that the thread runs clockwise 1
⦁
pull the thread from the right into the slot
Removing the bobbin case
⦁
raise the needle
⦁
turn power switch to «0» (off)
⦁
open bobbin cover
⦁
grasp the latch of the bobbin case
⦁
remove the bobbin case
Bobbin thread cutter
⦁
pull the thread over thread cutter 2 to cut it
⦁
close the cover
Insert the bobbin case
⦁
hold the bobbin case latch
⦁
Finger of the bobbin case 1 points upwards.
⦁
insert the case so that it clicks into place
⦁
pull the thread to the left under the spring
⦁
until it lies in the T-shaped slit at the end of the spring
⦁
pull the thread
►
the bobbin must turn clockwise
2
1
1
Exchanging bobbin case
To Next Page
