Calibrating the buttonhole foot No. 3A
⦁
attach buttonhole foot No. 3A
►
the needle is not threaded
⦁
touch «Start/Stop»-button
⦁
lower buttonhole foot No. 3A
►
the buttonhole foot No. 3A moves forward and backwards
►
the buttonhole foot No. 3A is calibrated and the sewing computer indicates
whether the calibration was successful
The buttonhole foot No. 3A is adjusted to this sewing computer and should
only be used on this sewing computer.
⦁
touch «Calibration»-icon
It is recommended to save the data and the settings of the sewing computer
before the update is carried out.
⦁
touch icon 1
►
the data of the sewing computer is saved on the USB stick
⦁
touch «Update»-icon 2 to start the procedure
It is then checked if:
►
a BERNINA USB stick is inserted
►
there is enough free space available
►
the correct software version is on the stick
►
the data and settings are accepted
After the successful update a message appears and sewing-/embroidery
computer is ready for use.
►
if the update cannot be started or if there are problems during the update
process, an error message appears
If the data and the settings aren't on the sewing computer anymore after the
update:
⦁
touch icon 3
►
the data on the stick are saved on the sewing computer
⦁
insert BERNINA USB stick with the new software version
⦁
touch «Update»-icon
Do not remove the BERNINA USB stick until there is a message
which indicates the end of the update.
Update
1
3
2
To Next Page
Loading...
