BestCode NExT 88SHS - Page 172

BestCode Next Series 8 Technical Manual October 2022 Page 158 of 290
Prompt Code
Prompt Name
Prompt Description
01-000F
NO PROMPT OCCURS
Reset All Counters
Written to the event log to indicate that all Counters were in fact reset.
Prompt Code
Prompt Name
Prompt Description
01-0010
Complete
"The print job has reached the end."
Displayed to indicate that printing has stopped because a print count has reached the termination
point. Only occurs when “Counter Resets” are set to “Print Off”
Prompt Code
Prompt Name
Prompt Description
01-0011
Log Reset
Reset Event Log. Are you sure?
Solution 1:
Press OK to Erase the entire Event Log.
Solution 2:
Press Cancel to close the prompt.
Prompt Code
Prompt Name
Prompt Description
01-0012
NO PROMPT OCCURS
Reset Event Log.
Written to the event log to indicate that Event Log was in fact reset.
Prompt Code
Prompt Name
Prompt Description
01-0013
Log Reset
Reset Viscosity Log. Are you sure?
Solution 1:
Press OK to Erase the Viscosity Log.
Solution 2:
Press Cancel to close the prompt.
Prompt Code
Prompt Name
Prompt Description
01-0014
NO PROMPT OCCURS
Reset Viscosity Log.
Written to the event log to indicate that Viscosity Log was in fact reset.
Prompt Code
Prompt Name
Prompt Description
01-0015
Log Reset
Reset Phase Log. Are you sure?
Solution 1:
Press OK to Erase the Viscosity Log.
Solution 2:
Press Cancel to close the prompt.
Prompt Code
Prompt Name
Prompt Description
01-0016
NO PROMPT OCCURS
Reset Phase Log.
Written to the event log to indicate that Phase Log was in fact reset.
Prompt Code
Prompt Name
Prompt Description
01-0017
Log Reset
Reset Remote Command Log. Are you sure?
Solution 1:
Press OK to Erase the Remote Command Log.
Solution 2:
Press Cancel to close the prompt.
Prompt Code
Prompt Name
Prompt Description
01-0018
NO PROMPT OCCURS
Reset Remote Command Log.
Written to the event log to indicate that Remote Command Log was in fact reset.