BestCode NExT 88SHS - Page 177

BestCode Next Series 8 Technical Manual October 2022 Page 163 of 290
Prompt Code
Prompt Name
Prompt Description
03-8002
Firmware Fault
Firmware could not be loaded.
Displayed to indicate that the firmware version on the USB drive is not valid.
Solution 1:
Erase USB and re-load correct firmware files to USB stick. Repeat Firmware Update.
Solution 2:
Perform J-Link Firmware Load.
Solution 3:
If issue persists, contact BestCode support or replace Main PCB.
Prompt Code
Prompt Name
Prompt Description
03-8004
Firmware Fault
Loading older software versions not permitted.
Displayed to indicate an attempt to load software with a lower version than what is currently installed.
Solution 1:
Erase USB and re-load correct firmware files to USB stick. Repeat Firmware Update.
Solution 2:
Perform J-Link Firmware Load using newest Firmware Version.
Prompt Code
Prompt Name
Prompt Description
03-8005
Firmware Fault
"Compatible USB required to perform firmware update."
Displayed to indicate that a USB drive is required to complete firmware installation.
Solution 1:
Insert USB with proper Firmware file structure.
Solution 2:
USB is damaged, replace the USB with a different stick
Solution 3:
USB socket or driver is damaged on the Main PCB, replace the Main PCB.
Prompt Code
Prompt Name
Prompt Description
04-0001
Memory Warning
"Print memory could not be saved."
Displayed to indicate that the attempt to save charge data aka Template data, failed.
Solution 1:
Reformat Memory
Solution 2:
Reload Firmware
Prompt Code
Prompt Name
Prompt Description
04-0002
Default
"System settings have restored to factory defaults."
Displayed to indicate that factory defaults are now in effect.
Prompt Code
Prompt Name
Prompt Description
04-0004
Messages
"All messages will be erased."
Displayed to inform the user that all messages will be erased, except for default messages, and asks
for confirmation.
Solution 1:
YES to delete all messages. Cancel to exit.
Prompt Code
Prompt Name
Prompt Description
04-0005
Graphics
All graphics will be erased.
Solution 1:
Press OK to delete all graphics.
Solution 2:
Press Cancel to close the prompt.
Prompt Code
Prompt Name
Prompt Description
04-0006
-
“Running script %ls”
Reports script name to the Event Log when run.