To commission the Ink System, We begin with an Empty Ink Tank (Stage 1 Image). 1x 946ml bottle of Ink is added to
the Tank (Stage 2 Image). The machine will use 400ml of Ink to prime the system, leaving 546ml in the tank (Stage 3
Image).
The Ink Low warning occurs at 400ml of ink in the Tank (Stage 4 Image).
The difference then between commissioning the system and needing to add a bottle of ink is only 146ml. This effect
will give the appearance that the machine is quickly consuming ink, which is a misconstrued fact.
When the Ink Low warning goes active, add 1 bottle of ink and begin consumption testing. (Stage 5 Image) It will be at
a total volume of 1346ml. It can be found that the time from 1 bottle added from a low condition to the next add will
be in line with the listed consumption charts.
To Next Page
Loading...
