Beta RR250 - Removal of Flywheel; Removal of Pick-Up Unit

2
22
B
A
1
2
ENGINE DISASSEMBLY
Removal of flywheel nut.
2.4.3 REMOVAL OF FLYWHEEL
Block the flywheel using the special tool A (cod.
026140040 000) and remove the fastening nut
securing the flywheel to the crankshaft.
Note: Once the nut has been unscrewed, pay
attention to the special elastic washer placed
between the nut and the flywheel.
To remove the flywheel, tighten the extractor B
(code 3625173) onto the threaded part on the
flywheel.
Keep the extractor blocked with a spanner and
tighten the screw on the extractor using a box
spanner.
Release of flywheel using special tool B.
Removal of pick-up unit.
2.4.4 REMOVAL OF PICK-UP UNIT
Remove pick-up unit 1 by loosening the two fixing
screws 2.