2
INTRODUCTION
www.betamotor.com
Carbon monoxide
•
Exhaust gases contain carbon monoxide, which
is poisonous. Carbon monoxide may cause loss
of consciousness and lead to death. If the en-
gine needs to be started, make sure the loca-
tion is well-ventilated. Never start the engine
indoors.
•
The engine can be started indoors only if fitted
with the appropriate exhaust gas extraction de-
vices.
Petrol
•
Petrol is extremely flammable and can be ex-
plosive under certain conditions.
•
Keep sources of heat, sparks and flames away
from the work area.
•
Always work in a well-ventilated area.
•
Never use petrol as a solvent for cleaning. Do
not handle it unless strictly necessary.
•
Never use petrol to clean components by means
of compressed air.
•
Keep out of the reach of children.
Engine oil
•
Motor oil can cause skin conditions if it remains
in contact with the skin often and for prolonged
periods.
•
In case of contact with engine oil, wash with
soap and water as soon as possible.
•
In case of contact with the eyes, rinse them
with plenty of water and seek medical advice.
•
If swallowed, do not induce vomiting in order
to prevent the product from entering into the
lungs; seek immediate medical advice. If you
believe the product has entered the lungs, take
the person concerned to hospital immediately.
•
Waste oil contains dangerous substances that
are harmful for the environment. In order to
change it one must be equipped for disposal,
in compliance with applicable laws.
•
Do not discard waste oil into the environment.
•
Keep out of the reach of children.
INTRODUCTION
This publication is intended for workshops specialised in repairing mopeds and motorcycles.
Where required, use special Betamotor tools.
Use Betamotor spare parts only. For their codes refer to the spare parts manual for the specific vehicle
or version.
The warranty and liability on vehicle safety lapses when maintenance or repairs:
• Are NOT performed by workshops specialised in repairing mopeds and motorcycles;
• Are NOT carried out carefully following the requirements contained in the technical documentation;
• Are NOT carried out using special Betamotor tools, where required;
• Are NOT carried out using Betamotor official spare parts.
Carefully read this manual in its entirety before working on the engine. Good knowledge of all compo-
nents making up the engine and all the procedures to be followed for inspection and maintenance help
extend the life of the engine.
The paragraphs feature schematic illustrations highlighting each topic in order to make the text immedi-
ately understandable.
Informative note
Betamotor S.p.A. is committed to a policy of ongoing improvement of its products. This is why you might
notice slight differences between the content of this document and the vehicle on which you are about
to carry out repairs and/or maintenance. Betamotor S.p.A. models are exported to a number of countries
where there are different rules concerning the Highway Code and vehicle type-approval procedures. Bet-
amotor S.p.A. therefore reserves the right to modify its products and technical documentation at any time
without prior notice, thank you for your understanding.
We respect and defend the environment
Everything we do has an impact on the whole Planet and its Resources. To safeguard the interests of
the entire Community, Betamotor S.p.A. would like to raise the awareness of customers and techni-
cal service operators on ways of using the vehicle and disposing of its parts entirely in compliance
with applicable regulations in terms of environmental pollution, waste disposal and recycling.
SAFETY
To Next Page
Loading...
