3
75
ENGINE CHECKS AND ASSEMBLY
3.8.7 CLUTCH UNIT ASSEMBLY
Lubricate the end of the primary gearbox shaft,
the internal centre bearing 4 and the roller
bearing 5. Fit the roller bearing 5 and the centre
bearing 4 on the clutch case 1. Mount the unit on
the primary shaft; in order to make insertion of
the clutch case easier, slightly turn the kickstart
idler gear (if present). Fit the washer 6, which
the clutch drum 2 rests against. Fit the sliding
pins 35 on the drum. Put on the safety washer
7 and, after having applied the medium strength
threadlocker, couple the lock nut 8.
EXPLODED VIEW OF CLUTCH UNIT:
1) Main transmission crown
2) Clutch hub
3) Pressure plate
4) Main transmission crown bushing
5) Rolled bushing
6) Washer
7) Washer
8) Nut
9) Complete lifter clutch push rod assembly
10) Lifter clutch push rod assembly
11) Bearing cage
12) Circlip
13) Spring washer
14) Ring
15) Special screws
16) Clutch driven disc
17) Clutch driving disc
18) Clutch driving disc
36) Ring
To Next Page
Loading...
