3
89
1
6Nm
60Nm
ENGINE CHECKS AND ASSEMBLY
3.11.1 IGNITION SYSTEM CHECK
Accurately degrease the various elements and
carry out the checks.
The main check is the one concerning the elec-
trical inspection which can be done by using a
standard tester. The measured resistance values
must comply with those in the table.
3.11.2
COUPLING OF IGNITION
SYSTEM TO CRANKCASE
Apply the pick up to the crankcase and insert the
gasket in the specific seat, after applying the in-
sulating silicone paste.
Cover the threading of the two screws 1 with me-
dium strength threadlocker and tighten them at a
torque of 6Nm.
Thoroughly degrease the crankshaft conical sec-
tion, apply the Woodruff key 8 in the appropri-
ate groove present on the crankshaft, couple the
flywheel 9, the elastic washer 5 and the nut 4,
after having spread the threading with medium
strength threadlocker.
Element Cables Resistance values
Pick up Red – Green 100Ω ± 20%
Stator
Red/Black – White/Red 14.7Ω ±15%
Yellow – Mass 0.61Ω ±15%
Yellow – White 0.18Ω ±15%
Coupling of pick up to crankcase.
Exploded view of flywheel. 4) M12x nut; 5) Elastic
washer; 8) Woodruff key; 9) Flywheel.
To Next Page
Loading...
