3
84
2
1
Bordo più
spesso
1
2
ENGINE CHECKS AND ASSEMBLY
3.9.3 PUMP UNIT ASSEMBLY
Grease the oil seal housing on the pump body
1. Position the oil seal 2 so that the thicker edge
faces the outside of the pump body. Insert the oil
seal, having it enter the seat very slowly to pre-
vent it from deteriorating. The oil seal edge must
be at the same height as the pump body (outer
side).
3.9.4 ASSEMBLY OF COMPLETE
CLUTCH COVER AND PUMP
UNIT
Apply a new gasket 1 placed between the right
crankcase half and the inner clutch cover using
the two reference pins 2 to keep it in place.
Couple the inner clutch cover to the right crank-
case half and rotate the centrifugal shaft until the
shaft meshes in the main gear.
Application of the oil seal to the pump body.
Positioning of gasket and reference pins.
To Next Page
Loading...
