Beta RR250 - Gearbox and Internal Gearshift Assembly

3
59
1
2
4
3
3
4
ENGINE CHECKS AND ASSEMBLY
3.4.5 GEARBOX AND INTERNAL
GEARSHIFT ASSEMBLY
Insert the entire primary 1 and secondary unit
2 into the respective seats on the left crankcase
half simultaneously. Remember to oil the gears
with plenty of gear oil and to grease the shafts
supporting them with graphite grease in the mat-
ing areas with the bearing. Make sure that all the
parts slide properly.
Insert the centre bearing 3 and the O-ring 4 on
the secondary unit.
Insertion of the gearbox in the left crankcase half.
Detail of centre bearing 3 and O-ring 4 coupled to the
secondary shaft.