KB / KB-UL (E4 + E6) 10/2021 page 11/147
Symbols on the type plate
Symbol Valid for Information
All chambers CE conformity marking
All chambers
Electrical and electronic equipment manufactured / placed on
the market in the EU after 13 August 2005 and be disposed
of in separate collection according to Directive 2012/19/EU
on waste electrical and electronic equipment (WEEE).
Not for UL chambers
GS mark of conformity of the “Deutsche Gesetzliche Unfall-
versicherung e.V. (DGUV), Prüf- und Zertifizierungsstelle
Nahrungsmittel und Verpackung im DGUV Test” (German
Social Accident Insurance (DGUV), Testing and Certification
Body for Foodstuffs and Packaging Industry in DGUV Test).
Not for UL chambers
The chamber is certified according to Customs Union Tech-
nical Regulation (CU TR) for the Eurasian Economic Union
(Russia, Belarus, Armenia, Kazakhstan Kyrgyzstan).
UL chambers only
The chamber is certified by Underwriters Laboratories Inc.
®
according to the following standards:
• UL 61010-1, 3
rd
Edition, 2012-05, Rev. 2015-07
• CAN/CSA-C22.2 No. 61010-1, 3
rd
Edition, 2012-05, Rev.
2015-07
• IEC/EN 61010-1:2014, 3
rd
Edition
1.7 General safety instructions on installing and operating the chambers
With regard to operating the chambers and to the installation location, please observe the local and national
regulations relevant for your country (for Germany: DGUV guidelines 213-850 on safe working in laborato-
ries, issued by the employers’ liability insurance association).
BINDER GmbH is only responsible for the safety features of the chamber provided skilled electricians or
qualified personnel authorized by BINDER perform all maintenance and repair, and if components relating
to chamber safety are replaced in the event of failure with original spare parts.
To operate the chamber, use only original BINDER accessories or accessories from third-party suppliers
authorized by BINDER. The user is responsible for any risk caused by using unauthorized accessories.
Danger of overheating due to lack of ventilation.
Damage to the chamber.
∅ Do NOT install the chamber in unventilated recesses.
Ensure sufficient ventilation for dispersal of the heat.
Observe the prescribed minimum distances when installing the chamber (chap. 3.4)
LABORATORY EQUIPMENT
43KM
To Next Page
Loading...
