KB / KB-UL (E4 + E6) 10/2021 page 24/147
3.2 Guidelines for safe lifting and transportation
The front castors of the chambers sizes 240 / 400 / 720 can be blocked by brakes. Please move the cham-
bers with castors only when empty and on an even surface, otherwise the castors may be damaged. After
operation, please observe the guidelines for temporarily decommissioning the chamber (chap. 22.2).
CAUTION
Risk of injury and damages by lifting heavy loads and by sliding or tilting of the
chamber due to improper transportation.
Injuries, damage to the chamber.
Transport the chamber in its original packaging only.
For moving or shipping, secure the chamber with transport straps.
∅ Do NOT lift or transport the chamber using the door, the handle, or the lower housing.
∅ Do NOT lift chambers sizes 400 / 720 by hand.
Lift chambers sizes 53 / 115 with the aid of four people in the area of all 4 chamber feet.
Lift chambers size 240 with the aid of 6 people or with a fork lifter. Set the fork lifter only
from the front or rear in the middle of the chamber.
Lift chambers sizes 400 / 720 using technical devices (fork lifter). Set the fork lifter only
from the front or rear in the middle of the chamber.
∅ Do NOT set the fork lifter from the chamber side.
• Permissible ambient temperature range during transport: -10 °C / 14°F to +60 °C / 140°F.
You can order transport packing for moving or shipping purposes from BINDER service.
3.3 Storage
Intermediate storage of the chamber is possible in a closed and dry room. Observe the guidelines for tem-
porary decommissioning (chap. 22.2).
• Permissible ambient temperature range during storage: -10 °C / 14°F to +60 °C / 140°F.
• Permissible ambient humidity: max. 70 % r.H., non-condensing
When after storage in a cold location you transfer the chamber to its warmer installation site, condensation
may form. Before start-up, wait at least one hour until the chamber has attained ambient temperature and
is completely dry.
To Next Page
Loading...
