KB / KB-UL (E4 + E6) 10/2021 page 96/147
14.4 Confirming a “set” alarm
Initial view with overtemperature safety controller
alarm.
The buzzer sounds (if not deactivated previously).
Press the “Info” button.
Temperature [°C]
Fan [%]
User Info Menu
08.03.2015 05:05:06
Submenu “Alarms” for alarm acknowledgement.
Safety controller overtemperature
Close Reset Home
Press the “Reset” button to confirm the alarm. If there is another active “set” alarm, you can also confirm it
with the “Reset” button. After confirming all active “set” alarms, the buzzer is off, and the initial view is
displayed.
As long as an alarm is still active, i.e. as long as the alarm cause is still valid, the alarm icon continues to
be displayed in the initial view.
To Next Page
Loading...
