Binder KB - Setup Wizard; Date and Time Settings

KB / KB-UL (E4 + E6) 10/2021 page 83/147
12.1 Setup wizard
The setup wizard will guide you sequentially through the important menus to configure your chamber
• Menu language
• Chamber name
• Date and time
• IP address
• Subnet mask
• Network name
• Gateway
• DNS 1
• DNS 2
Then the controller returns to the initial view.
Use the setup wizard only if you want to enter all the requested information, as no item can
be skipped.
You can configure the network settings (IP address, and the following) only if the DHCP sta-
tus is Off, otherwise the DHCP server would assign the network configuration.
If you try configuring any network settings while DHCP is enabled, (i.e. settings from menu item “IP Address”
on in the setup wizard), the message "DHCP enabled!” is shown. After confirming with Ok the Setup wizard
is cancelled and the controller returns to the initial display. The settings made up to then remain effective.
12.2 Date and time settings
To access the date and time settings, go to Menu > Settings > Date and time
Fixed value
08.03.2015 05:05:06
Submenu “Date and time”.
Select the desired function
and press the operating button.
..\ Date and time
Set date
Set time
Close Home