Binder KB - Cancelling a Week Program

KB / KB-UL (E4 + E6) 10/2021 page 67/147
Fixed value
08.03.2015 05:05:06
Submenu “Week program”.
Select “Start” to start an existing program
and press the operating button.
..\ Week program
Start
Stop
Close Home
The further procedure is equal to that described for the general menu.
Fixed value
08.03.2015 05:05:06
Submenu “Select program” (example).
Select one of the programs
and press the operating button to start the program
..\ Select program
Program0001
Program0002
Program0003
Close Home
10.2 Cancelling a running week program
To cancel a week program, go to Menu > Programs > Week program > Stop.
To cancel a running week program, you can also go to Quick menu > Week program > Stop.
The controller returns to the initial view.
Performance after manual program stop
The controller automatically changes to the “Fixed value” operation mode.
Before starting a program, check the temperature setpoint entered in the “Fixed value” operation mode.
After cancelling the program, the temperature will equilibrate to this value.
NOTICE
Danger of damages by too high or too low temperature after cancelling the program.
Damage to the charging material.
 Before starting a program, check the temperature setpoint of “Fixed value” operation and
if necessary adapt it.