EasyManua.ls Logo

Binder KB - Accident Prevention Measures

Binder KB
147 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
KB / KB-UL (E4 + E6) 10/2021 page 16/147
Cleaning and Decontamination
Penetration of water into the chamber
Inappropriate cleaning and decontamination agents
Enclosure of persons in the interior
Malfunction and Damage
Continued operation of the chamber during an obvious malfunction or outage of the heating or cooling
system
Contact with live parts during error status
Operation of a unit with damaged power cord
Maintenance
Maintenance work on live parts.
Execution of maintenance work by untrained/insufficiently qualified personnel
Electrical safety analysis during annual maintenance not performed
Trouble-shooting and Repairs
Non-observance of warning messages in the Service Manual
Trouble-shooting of live parts without specified safety measures
Absence of a plausibility check to rule out erroneous inscription of electrical components
Performance of repair work by untrained/insufficiently qualified personnel
Inappropriate repairs which do not meet the quality standard specified by BINDER
Use of replacement parts other than BINDER original replacement parts
Electrical safety analysis not performed after repairs
1.11 Operating instructions
Depending on the application and location of the chamber, the operator of the chamber must provide the
relevant information for safe operation of the chamber in a set of operating instructions.
Keep these operating instructions with the chamber at all times in a place where they are
clearly visible. They must be comprehensible and written in the language of the employees.
1.12 Measures to prevent accidents
The operator of the chamber must observe the local and national regulations (for Germany: the rule “Op-
eration of work equipment. Operation of refrigeration systems, heat pumps and refrigeration equipment”,
GUV-R 500 chap. 2.35) and take precautions to prevent accidents.
The manufacturer took the following measures to prevent ignition and explosions:
Indications on the type plate
See operating manual chap. 1.6.
Operating manual
An operating manual is available for each chamber.

Table of Contents

Related product manuals