Binder KB - Page 32

KB / KB-UL (E4 + E6) 10/2021 page 32/147
Fixed value
08.03.2015 05:05:06
General menu (next page)
(“Optional equipment” menu item is visible only with
optional chamber equipment)
..\ Menu
Measurement chart
Optional equipment
Sensor adjustment
Service contact
System information
Close Home
Controller mode
Switching between the operating modes “control off” or “fixed value”,
chap. 6.2.1
Event list Display of status information and errors, chap. 15
Alarms Alarm settings, chap. 14.5
Setpoints Setpoint entry in “Fixed value” operating mode, chap. 8
Safety controller Setting the safety controller, chap. 17.2 and 17.3
Programs Time and week programs, chap. 9 and 10
Import/Export Data transfer via USB interface, chap. 13
Settings General controller settings, chap. 12
Measurement chart Graphical display of the measured values, chap. 16
Optional equipment
Setting for optional equipment like zero-voltage relay control outputs,
alarm output, object temperature display, chap. 7
(menu item is visible only with optional chamber equipment)
Sensor adjustment
Adjustment menu for single-point and two-point adjustments (for Ser-
vice purpose)
Service contact
Service information
System information
Chamber information (model, name, serial no., firmware etc.)