48
5. Select the Start icon to begin the Practice Trial.
NOTE: There are an unlimited amount of practice reps. Practice Trials will have the same
properties (speed, torque, etc.) as the activity. Practice Trial results are not recorded.
6. To start the actual Activity Session, click the Stop icon. Alternatively, you can let go of the
attachment, letting it fall back to the Start position. When no movement is detected from the
shaft, the Activity Session will begin.
7. Complete the Activity Session (as shown in the Protocol Based Activity section) and a
message will appear “Activity Complete”.
8. Select the Results icon and then the Save icon if you want to save the results of your Activity
Session. Or return to the Home screen.
Practice Reps in Isometric Mode
1. Click the Start icon for a Practice session. The message “Arm will move to position, press
Start again” displays.
2. Click the Start icon. It will display “Arm in position, press Start to begin test”.
3. Click the Start icon and the Practice Trial begins. The Stop icon will be available.
4. Clicking the Stop icon will allow you to exit the Practice Trial.
NOTE: There are no Practice Trials available in Passive Mode.
To Next Page
Loading...
