www.bodor.com/service@bodor
.com
Table 2-7 Operating modes
Normal operation mode refers to the operation of the
equipment within the range of all functions.
Machine is controlled by
program or manually.
Personnel are outside the
danger zone.
Maintenance and
debug mode
Maintenance and debug mode refers to state of
machine during maintenance and debugging.
When the equipment is in
an abnormal state or needs
to be maintained.
The danger of laser rays.
1) The laser beam in operation is high-energy, invisible light!
2) It may severely burn the skin and hurt the eyes. The impact on vision can cause vision
damage and even blindness!
3) If you are debugging while the laser is working, you must wear laser protective glasses.
4) Thermal residues generated during laser processing can easily cause fire hazards.
1) Laser rays can hurt eyes! Do not look directly at the rays!
2) If you look at the processing position for a long time, visible rays may cause injury to the
operator. Especially in high-speed cutting, or processing such as galvanized steel, aluminum
and high-quality steel, the plasma generated will produce bright and strong light, which may
cause permanent damage to the retina.
3) The secondary rays during laser processing are dangerous! High-intensity visible rays can
cause permanent damage to the retina!
4) Do not look directly at the processing location without taking protective measures
5) Wear laser protective glasses when needed.
6) Cutting highly reflective materials can easily cause fire and may damage the laser and fiber,
it is not recommended to cut for a long time.
To Next Page
Loading...
