Bodor i5 Series - Page 72

www.bodor.com/service@bodor
.com
71
1KW
Thickness mm
1
3
1
2
Effect
2KW
Thickness mm
1
6
1
4
Effect
3KW
Thickness mm
1
8
1
6
Effect
4KW
Thickness mm
1
12
1
8
Effect
6KW
Thickness mm
1
20
1
12
Effect
Note: this parameter is for reference only, which cannot be used as the basis for acceptance or quality traceability
because different conditions on the site (plate quality, gas quality, etc.) influence a lot. It is the responsibility of Bodor
for the final explanation!
1) The cutting effect is subject to different fiber optics, material quality, gas, optical lenses, cutting graphics, etc., in
which case it is necessary to be adjusted according to the site conditions; (the plate model used for this parameter:
Q235 for carbon steel, 201 for stainless steel, 5# for aluminum, H6 of copper, and the plate thickness of the
theoretical thickness, but the actual thickness is slightly smaller than 0.2 ~ 0.5mm).
2) The cutting accuracy is affected by the quality of different material types and material surface, and installation
status of machine tool. As a result, we recommend that when cutting precision workpieces, the cutting speed is
reduced with the recommended speed below 12m/min.
3) Requirements for cutting gas: nitrogen (purity≧99.99%), oxygen (purity≧99.9%) for cutting.