www.bodor.com/service@bodor
.com
4) At the time of cutting highly reflective materials such as copper and aluminum,
attentions should be paid to adjust the process, during which the limit thickness is not recommended for
continuous and long-term processing.Bodor Power can cut highly reflective materials under normal cutting
conditions; but we do not recommend long-term cutting.
Tips:
1) We recommend that the layout spacing is ≥0.8 time the thickness of the plate to avoid thermal deformation and
poor cutting.
2) The intensive cutting within a small range of this processing method will cause damage to the lathe bed and the
countertop, which is not covered by the product warranty.
3) In the event of long-stroke continuous cutting (single cutting straight line> 2m), thermal deformation of the plate
will affect the final straightness, which is not covered by the product warranty.
To Next Page
Loading...
