Job Nature：Precision maintenance of the equipment.Calibration of X,
Y-axis verticality and X,Y-axis gear rack back lash
Interval: once/two and a half years
Interval: 5000h/time.
Tools/Materials: Dial indicator, micrometer,Fang Chi, internal and
external hex wrench, cleaning cloth, Gear rack
meshing backlash tooling.
Job description: disconnect the x-direction dust-proof cloth from the
beam, remove the x-axis protection plate and the left
and right guard plate of the cross beam to conduct
vertical inspection on the X and Y axis. The tolerance
of X and Y two-way marking is ≤ 0.03mm/500mm,
so as to ensure that the vertical of X and Y axis is ≤
0.03mm/500mm. Check the reverse clearance of
x-axis gear rack engagement ≤ 0.02mm.
Safety precautions: Pay attention to safety during operation!
Job Nature
：
Inspection and cleaning of slag on the countertop blade.
Interval: 100h/time.
Tools/Materials: Sword grid cleaner (optional), electric hammer, iron
hammer, etc.
Job description: Clean the blade regularly, choose electric hammer or
iron hammer to clean the blade by vibration (pay
attention to the table and personal safety) or choose
our special sword grid cleaner. Can contact our
customer service engineer for consultation.
To Next Page
Loading...
