BONFIGLIOLI Vectron Agile Series - Default Chapter; Table of Contents

Probus DP V1 Agile 306/2010
General Information on the Documentation
CONTENTS
1
General Information on the Documentation.................................................................. 5
1.1 Instruction Manuals ............................................................................................. 5
1.2 Used Pictograms and Signal Words ...................................................................... 6
2 General Safety Instructions and Information on Use .................................................... 7
2.1 General Information ............................................................................................. 7
2.2 Purpose of the Frequency Inverters..................................................................... 7
2.3 Transport and Storage.......................................................................................... 7
2.4 Handling and Installation..................................................................................... 8
2.5 Electrical Installation ........................................................................................... 8
2.6 Information on Use ............................................................................................... 9
2.6.1 Using external products............................................................................................ 9
2.7 Maintenance and Service...................................................................................... 9
2.8 Disposal ................................................................................................................ 9
3 Communication Options............................................................................................... 10
3.1 VPlus PC-Software.............................................................................................. 10
4 Installation of an optional Communication Module ..................................................... 11
4.1 Assembly............................................................................................................. 11
4.2 Disassembly ........................................................................................................ 11
5 Connection ................................................................................................................... 12
6 Commissioning via the Operator Panel........................................................................ 13
6.1 Menu for setting up the Communication............................................................ 13
6.2 Select the Protocol ............................................................................................. 14
6.3 Set the Communication Parameters................................................................... 14
7 Profibus ........................................................................................................................ 15
8 Baud Rate Setting / Line Length.................................................................................. 16
9 Setting the Station Address ......................................................................................... 16
10 LED Indicators .............................................................................................................. 17
11 Status Parameters........................................................................................................ 18
12 Error Behavior .............................................................................................................. 18
13 Setting PPO Type ......................................................................................................... 19
13.1 Configuration Process on the DP Master ............................................................ 20
14 Commands SYNC / FREEZE .......................................................................................... 22
15 Available Objects / Scanning Times............................................................................. 22
16 Handling of the Objects ............................................................................................... 25
16.1 Parameter Access via Communication Channel PKW ......................................... 25