bora M Pure - Cooktop Functions

Functions and operation
EN
bora.com 95
5.5.4 Switching the fan off
Switching the fan off
u
Swipe downwards to power level 0
or
u tap until power level 0 is reached
or
u long press on the fan button
or
u Long press on the fan power level in the multi-
function display.
T When the extractor is switched off, the automatic
after-run function is activated.
5.5.5
Automatic after-run
The cooktop extractor continues to run at a lower level
and switches off automatically after a defined time. The
duration of the after-run function can be set in the
menu (factory setting is 20 minutes).
Switching off the automatic after-run early
u
Long press on the fan button
BORA expressly recommends use of the
cooktop extractor after-run function.
5.5.6
Filter service display
The cooktop extractor filter service display is
automatically activated when the end of the activated
charcoal filter service life is reached (only in
recirculation mode).
T is displayed in the multi-function display.
T The filter service display is shown every time the
cooktop extractor is switched on and remains active
until the filter has been changed and the filter service
display has been reset (see"6.3Menu item 3: Show
filter status and reset filter service display").
T The cooktop extractor can still be operated without
limitations.
The components of the grease filter require
regular cleaning regardless of the filter service
display, see “8 Cleaning and Maintenance”.
5.6
Cooktop functions
5.6.1 Pan size recognition
On induction cooktops the cooking zone recognises the
size of the cookware automatically and only targets the
energy at that area. An induction cooking zone is not
working if the display alternates between
/ .
Possible causes:
T Missing cookware
T Unsuitable cookware
T The base diameter of the cookware is too small
If no pot is detected 10 minutes after setting a power
level, the cooking zone will switch off automatically.
Permanent pan size recognition
The appliance automatically recognises cookware and
activates the corresponding cooking zone controls.
Manual selection of the cooking zone is not necessary
(see"6.7Menu item 7: Permanent pan size
recognition").
Do not simply rely on the pan size recognition
function on induction cooktops; always switch
the appliance off after use.
5.6.2
Selecting a cooking zone
u
Tap the cooking zone display.
The cooking zone operation is activated and settings
can be changed for 2 seconds.
5.6.3
Setting cooking zone power
levels
After selecting the cooking zone, the power level can be
set in 3 different ways:
u by swiping until you reach the required power level
or
u by tapping a certain position on the slider
or
u by tapping or .
Repeat this process to operate further cooking zones if
necessary.
The power level set is shown in the respective
cooking zone display.
Two seconds after the power level is changed,
the operating panel display automatically
returns to the standard display.