bora M Pure - Securing the Cooktop; Making a Connection with the Back Panel in Installation Variant a; Inserting the Activated Charcoal Filter

Installation
EN
bora.com 119
Make sure that the cooktop sealing tape is flat
against the worktop in the case of surface
mounting.
Make sure that the cooktop sealing tape is well
sealed all the way round in the case of flush
installation.
Height adjustment plates for flush installation
(optional)
T
The height adjustment plates are self-adhesive to
prevent slipping during installation.
u If applicable, insert the height adjustment plates.
u Place the height adjustment plates next to the
sealing tape.
1
2
Fig.9.29
Positioning the height adjustment plates
[1] Cooktop
[2] Height adjustment plate
1 2
Fig.9.30
Height adjustment plates
[1] Sealing tape
[2] Height adjustment plate
9.7.10
Securing the cooktop
u
Secure the cooktop to the worktop with the fixing
bracket on the installation clamp.
u Tightening torque: max. 2.2Nm.
1
2
3
Fig.9.31
Securing the cooktop in the middle
[1] Cooktop
[2] Mounting bracket
[3] Fixing bracket
9.7.11
Making a connection with the
back panel in installation
variant A
1
2
3
Fig.9.32
Connection with the back panel
[1] Telescopic pull-out
[2] Adhesive tape
[3] Back panel of unit
u Push the telescopic pull-out until it is tight up against
the back panel of the unit.
T With the telescopic pull-out the distance to the back
panel of the unit can be flexibly bridged.
u Check that the telescopic pull-out fits accurately, is
flush with the cut-out on the back panel of the unit
and closes it off.
u Secure the telescopic pull-out to the back panel of
the unit using the adhesive tape.
9.7.12
Inserting the activated
charcoal filter
See chapter Cleaning and maintenance, “7.6
Replacing the activated charcoal filter”