General information
EN
86 bora.com
1 General information
These instructions contain important information to
protect you from injury and prevent damage to the
appliance. Please read these instructions carefully
before installing or using the appliance for the first time.
Other documents apply alongside these instructions.
Please by all means adhere to all documents that form
part of the scope of delivery.
Assembly, installation and commissioning must always
occur in line with national laws, regulations and
standards. The work must be performed by qualified
specialists who know and comply with the additional
regulations of the local energy supply companies.
All safety and warning information as well as the
handling instructions in the accompanying documents
must be observed.
1.1
Validity of the operating
and installation
instructions
These instructions apply to several appliance versions. It
is therefore possible that some of the features described
do not apply to your appliance. The details of the figures
contained herein may differ from some appliance versions
and are to be understood as schematic diagrams.
1.2
Liability
. BORA Holding GmbH, BORA Vertriebs GmbH & Co KG,
BORA APAC Pty Ltd and BORA Lüftungstechnik GmbH –
hereinafter referred to as BORA – do not assume any
liability for damage arising from disregard for or non-
adherence to the documents included in the scope of
delivery!
Furthermore, BORA shall not be held liable for damage
caused by improper installation or failure to observe the
safety and warning information!
1.3
Product conformity
Directives
The appliances meet the following EU/EC directives:
T
2014/30/EU EMC Directive
T
2014/35/EU Low Voltage Directive
T
2009/125/EC Ecodesign Directive
T
2011/65/EU RoHS Directive
Standards
The appliances conform to the following standards:
T
IEC 61000-3-12
1.4
Presentation of
information
We use standard formatting, numbering, symbols, safety
instructions, terms and abbreviations so that you can
work quickly and safely when using this manual. The
article described in these instructions is hereinafter also
referred to as an appliance.
Instructions are indicated with an arrow.
u
Always follow all instructions in the prescribed order.
Enumerations are indicated with a bullet point at the
start of the line:
T
Enumeration 1
T
Enumeration 2
Information notes point to special features that
must be taken into account.
1.4.1
Safety and warning
instructions
The safety and warning instructions in this manual are
emphasised with symbols and signal words. Safety and
warning instructions are structured as follows:
ö
DANGER
Type and source of danger
Results of non-compliance
u
Measures to minimise risk
Please note:
T
warning symbols draw attention to a high risk of
injury.
T
The signal word indicates the severity of that risk.
To Next Page
Loading...
Need help?
General
