bora S Pure User Manual

Cleaning and maintenance
EN
bora.com 125
Heavy soiling
u Remove heavy soiling and marks (limescale marks,
mother-of-pearl-like shiny marks) using cleaning
products while the cooktop is still warm.
u Wipe off any food that boils over with a damp cloth.
u Remove any remaining dirt with the glass ceramic
scraper.
u Always remove any seeds, crumbs or similar that fall
onto the cooktop during cooking immediately to
prevent the surface getting scratched.
Any changes in colour or glossy spots do not mean that
the cooktop is damaged. They do not affect the
functionality of the cooktop or the stability of the glass
ceramic panel.
Changes in the colour of the cooktop are the result of
residues which have not been removed and have burnt
on.
Glossy spots are the result of wear by the pan base,
especially if aluminium-based cookware or unsuitable
cleaning agents are used. These are difficult to remove.
7.4 Cleaning the cooktop
extractor
The air inlet nozzle and stainless steel grease filter
absorb the greasy particles from cooking vapours.
u Make sure that the cooktop and cooktop extractor
are switched off.
u Wait until the fan display shows .
u Clean the cooktop extractor in accordance with the
cleaning cycles.
u Clean the surfaces of the extraction system using a
soft, damp cloth, detergent or a mild window
cleaning agent.
u Soften dried on dirt using a damp cloth (do not
scrape it off!).
7.4.1 Removing the components
Removing the Pure air inlet nozzle
Prerequisite: the fan display shows .
u Reach into the access opening of the air inlet nozzle
with your finger.
u Pull the air inlet nozzle up and out.
1
2
Fig.7.1
Removing the air inlet nozzle
[1]
Air inlet nozzle
[2]
Access opening
Removing the stainless steel grease filter
u Take hold of the stainless steel grease filter by the
handle.
u Pull the stainless steel grease filter up and out of the
suction opening.
1
2
3
Fig.7.2
Removing the stainless steel grease filter
[1]
Stainless steel grease filter
[2]
Handle
[3]
Inlet opening
7.4.2 Cleaning the air inlet nozzle
and stainless steel grease
filter
If the stainless steel grease filter can no longer
be fully cleaned, it must be replaced (Warranty,
technical service, spare parts, accessories).
Manual cleaning
u Use a cleaner and degreaser in one.
u Rinse the components with hot water.
u Clean the components with a soft brush.
u Rinse the components well after cleaning.

bora S Pure Specifications

General

Number of Cooking Zones	4
Control Type	Touch control
Power Levels	9
Frequency	50/60 Hz
Type	Induction
Supply Voltage	220-240 V
Safety Features	Child Lock
Installation Type	Built-in