Cleaning and maintenance
EN
128 bora.com
Inserting the activated charcoal filter
u
Remove the packaging from the activated charcoal
filter.
u
Position the activated charcoal filter correctly with
the help of the printed symbols (arrow left, grip strap
right).
u
Hold the activated charcoal filter at both ends.
u
Bend the activated charcoal filter into a cylindrical
shape so that both ends of the filter are opposite
each other.
Fig.7.7
Activated charcoal filter
[1]
Activated charcoal filter
[2]
Grip strap
u
Tilt the activated charcoal filter towards you slightly
and insert it through the inlet opening.
u
Guide the left end of the filter into the opening in the
filter housing.
Fig.7.8
Inserting the activated charcoal filter through
the vent opening
u
Push the activated charcoal filter into the filter
housing until it will go no further (to do this, you can
place one finger between the slats and gradually
push the filter into the housing).
T
The end position of the activated charcoal filter is
reached when the filter has been fully pushed inside
the filter housing.
Fig.7.9
Placing the activated charcoal filter in the end
position
u
Inside the inlet opening push the filter replacement
cover until it comes to a stop in the filter housing
opening.
u
Check that the filter replacement cover is positioned
correctly.
Fig.7.10
Inserting the filter replacement cover
[1]
Filter replacement cover
[2]
Inlet opening
u
Insert the stainless steel grease filter and the air inlet
nozzle.
u
Reset the filter service display (see"6.3Menu item 3:
Show filter status and reset filter service display").
To Next Page
Loading...
Need help?
General
