Bosch Denoxtronic 1.1 - User Instructions; Important Notes; Intended Use

1 689 989 403 2019-03-01| Robert Bosch GmbH
1. Symbols used
1.1 In the documentation
1.1.1 Warning notices - Structure and meaning
Warning notices warn of dangers to the user or people
in the vicinity. Warning notices also indicate the con-
sequences of the hazard as well as preventive action.
Warning notices have the following structure:
Warning
symbol
KEY WORD – Nature and source of hazard!
Consequences of hazard in the event of fail-
ure to observe action and information given.
¶ Hazard prevention action and information.
The key word indicates the likelihood of occurrence and
the severity of the hazard in the event of non-observance:
Key word Probability of
occurrence
Severity of danger if in-
structions not observed
DANGER Immediate impend-
ing danger
Death or severe injury
WARNING Possible impending
danger
Death or severe injury
CAUTION Possible dangerous
situation
Minor injury
1.1.2 Symbols in this documentation
Symbol Designation Explanation
!
Attention Warns about possible property damage.
i
Information Practical hints and other
useful information.
1.
2.
Multi-step
operation
Instruction consisting of several steps.
e
One-step
operation
Instruction consisting of one step.

Intermediate
result
An instruction produces a visible inter-
mediate result.
"
Final result There is a visible final result on com-
pletion of the instruction.
1.2 On the product
! Observe all warning notices on products and ensure
they remain legible.
Disposal
Dispose of used electrical and electronic
devices, including cables, accessories and
batteries, separately from household waste.
Symbols used | Denoxtronic 1.1 | 19 en
2. User instructions
2.1 Important notes
You can find relevant information on the use of the
components in the separate ESI[tronic] repair instruc-
tionsDenoxtronic 1.1 under the sections "Safetyin-
structions", " Repair instructions" and "Lubricants and
auxiliary materials". These must be carefully studied
prior to start-up, connection and operation and must
always be heeded.
To check for leaks by means of pressurized gases, the
tester must be certified at least to DINENISO9712
Level 1.
2.2 Safety instructions
All safety instructions can be found in the separate
ESI[tronic] repair instructions Denoxtronic 1.1 in the
section "Safety instructions". These instructions should
be carefully studied prior to start-up, connection and
operation of the diagnostic device and must always be
heeded.
2.3 Intended use
The devices and components of tester set
0986610551 are intended exclusively for test
and repair of the AdBlue-Fördermoduls of the type
Denoxtronic 1.1.
! Nonobservance can lead to accidents and damage.
2.4 Training
Testing and repairs of the AdBlue supply module type
Denoxtronic 1.1 may only be performed by qualified
and trained personnel. We recommend user training in
testing and repair at the the AA training center.