Bosch DVR-8K - Page 32

30 en | Connections and settings Digital Video Recorder
F01U | 1.0 | 2007.11 User Manual Bosch Security Systems
3.15.1 Preset settings
Preset position is the function to program camera monitoring positions (preset positions) associated
with position numbers.
By entering the position numbers, you can move cameras to the preset positions.
Note:
To activate this function, you need to register the preset positions of the
PTZ camera.
3.15.2 To program preset positions
1. Move the camera to a point you wish by using the v/V/b/B.
2. Press SET or click the [SET] icon.
3. Select the preset number you wish to register.
4. Press ENTER or click the
icon.
The position and its number are memorized.
5. Repeat steps 1-4 to add additional positions.
Note:
Preset numbers from 0 to 255 are available on this unit but the actual
preset range differs depending on PTZ cameras.
3.15.3 Changing to a preset position
The following function is available only with cameras provided with the preset function. The preset
function makes the PTZ camera move to the programmed preset position. It is necessary to program
preset positions for the PTZ camera beforehand.
1. Press the MOVE button or click the [MOVE] icon.
2. Use number buttons to enter the memorized preset position’s index number then press ENTER
or click the
icon. The camera moves to the preset position and the picture of the camera
in that position appears on the monitor.
3.15.4 To clear the preset position
You can clear a memorized preset position.
1. Press the CLEAR button or Click the [CLEAR] icon.
2. Use number buttons to enter the memorized preset index number, then press ENTER or Click
the
icon to clear the preset positions.
Note:
This function may not be available depending on PTZ cameras.