140 en | Event messages PRAESENSA
2020-09 | V1.20 | PRAESENSA 1.20 Configuration manual Bosch Security Systems B.V.
– number of times the message(s) of the call should be repeated
– whether or not there was live speech in the call
– name of the audio input used for live speech (if applicable)
– name(s) of the end tone/message(s) of the call
– name(s) of the output(s) of the call
– For a replay call:
– reference to the original call id
– call definition name used for the call
– priority of the call
– routing scheme (always non-partial for the monitor replay phase and partial or non-
partial for the broadcast replay phase).
– timing scheme (always immediate)
– name(s) of the output(s) of the call
Only routing that is part of the call (announcement) is logged.
Event: CallTimeout
Group: Call
Occurrence: Logs the time‑out of a (stacked) call.
Originator: The system controller as device
Extra information: List of zones that did not receive this call completely.
General device events
Event: Emergency state acknowledge
Group: General
Occurrence: Logs acknowledge of the evacuation alarm.
Originator: Device, control input or Open Interface client that acknowledged the alarm.
Event: Emergency state reset
Group: General
Occurrence: Logs the reset of the evacuation alarm.
Originator: Device, control input or Open Interface client that reset the alarm.
Event: Emergency state active
Group: General
Occurrence: Logs the set/start of the evacuation alarm.
Originator: Device, control input or Open Interface client that set the alarm.
Event: Unit connect
Group: General
Occurrence: Logs the connection of a device.
Originator: Device that connected.
Extra information: Not available on Open Interface clients.
To Next Page
Loading...
