Bosch PRAESENSA PRA-CSLD - From Installation to Configuration

PRAESENSA Configure the system | en 47
Bosch Security Systems B.V. Configuration manual 2020-09 | V1.20 | PRAESENSA 1.20
Front panel indicators
The front panel indicators indicate correct functionality and faults. The table following
indicates the active state.
To make device identification visible, see System composition, page 40 .
Front panel indicators
Device fault present Yellow Power on Green
Network link present
Network link lost
Standby for redundancy
Green
Yellow
Blue
Identification mode /
Indicator test
All LEDs blink
Rear panel indicators and controls
The rear panel indicators indicate correct functionality and faults. The table following
indicates the active state.
To make device identification visible, see System composition, page 40 .
Rear panel indicators and controls
SD card busy; do not
remove
Green 100Mbps network
1Gbps network
Yellow
Green
Device fault present Yellow Power on Green
Device reset (to factory
default)
Button Identification mode /
Indicator test
All LEDs blink
Refer to
– Logon the application, page 35
– Optional: Install Dante Controller, page 27