82 en | Configure the system PRAESENSA
2020-09 | V1.20 | PRAESENSA 1.20 Configuration manual Bosch Security Systems B.V.
Item Value Description
Live speech Selection
Yes / No
If the announcement must contain live
speech, set the Live speech option to Yes. If
the announcement does not contain live
speech, set it to No. If No is selected a
Schedule announcement could be selected
(see Schedule following).
Attenuation Selection
(0dB‑20dB)
Adjust the attenuation to set the volume level
of the live speech.
End tone Selection If the announcement must use an end tone,
select a tone from the End tone dropdown
list. See
Recorded messages, page 68
and
Tones, page 153
for an overview of
pre‑defined .WAV audio files.
Attenuation Selection
(0dB‑20dB)
Adjust the attenuation to set the volume level
of the End tone.
Continue call Selection No /
After
interruption
No stops the announcement immediately if it
was overruled by another announcement.
After interruption continues or restarts the
announcement if it was overruled by another
announcement and/or not completed.
IMPORTANT: From software release 1.10
onwards, Continue call is forced set to NO
when Live speech is set to Yes and Priority is
set to a priority higher than 223 (i.e. an
evacuation announcement/call).
Audio input Selection
<Default> /
input
If Live speech is set to Yes, use the Audio
input list to specify the input that must be
used. Notice that the inputs 9 up to 16 are
secured (Dante/AES67) channels to the
amplifier.
Select <Default > if the Live speech is
originating from a call station (microphone).
Schedule Selection
Enable / Disable
If Live speech is set to No, the schedule
could be set.
Enable: will enable announcement scheduling
and will remove the maximum call duration.
Enter the start time of the first
announcement in the Start time text box.
Start time Enter
hh/mm/
Enable/Disable
day
Enter the start time of the first
announcement in the Start time text box and
Enable the days on which the announcement
schedule is active.
To Next Page
Loading...
