PRAESENSA Configure the system | en 83
Bosch Security Systems B.V. Configuration manual 2020-09 | V1.20 | PRAESENSA 1.20
Item Value Description
End time Enter
hh/mm
Enter the time to end the schedule
announcement on the enabled day(s). After
the End time, the announcement will not be
repeated.
Interval Enter
hh/mm
Enter the interval time period in the Interval
text box.
Add Button A new call definition can be added and
defined.
Rename Button An existing call definition can be renamed.
Automatically this name is replaced
everywhere in the configuration where this
call definition is used.
Delete Button An existing call definition can be deleted
from the system configuration.
Submit Button Click the Submit button to store the settings:
Notice that you always have to Save the
configuration. See
Save configuration, page
102
.
Add (create) a call definition
1. Click the Add button to add/create a new call definition.
2. Enter the name of the new call definition in the Name text box:
– It may consist of up to 16 characters, maximum.
3. Click the OK button to add the call definition to the list of call definitions in the system.
4. Select, enable or disable each of the items (see previous table) to define the call
definition:
5. Click the Submit button to store the changes:
– Note that the changes are not permanent until the configuration is saved. See
Save
configuration, page 102
.
Delete a call definition
Proceed as follows to delete a call definition:
1. Select the call definition that has to be deleted from the Name dropdown list.
2. Click the Delete button to delete the call definition.
– A pop-up window asks to confirm this choice.
3. Click the OK button to confirm that the call definition must be deleted:
– The deleted call definition is no longer available from the Name dropdown list.
4. Click the Submit button to store the changes:
– Note that the changes are not permanent until the configuration is saved. See
Save
configuration, page 102
.
To Next Page
Loading...
