PRAESENSA Configure the system | en 95
Bosch Security Systems B.V. Configuration manual 2020-09 | V1.20 | PRAESENSA 1.20
Configure call station extension button action
In the Call station extension section, the properties of the buttons of the call station extension
can be defined. To do so:
1. Click the + of the (call station) Extension row:
– A screen appears listed the following items.
2. Select the items to configure the actions of the Call station extension
Item Value Description
1 xxx [#01] Static text Shows the number and name of each of the buttons of the
call station extension selected and cannot be changed.
Operation Selection Select the Operation of the Function which is selected in
section
Call station, page 59
. See also
Assigning an
operation, page 84
.
BGM channel
selection
Enable /
Disable
BGM channel selection is only available when the Function
Select zone(s) is selected.
Enable: Selection of the BGM channel(s) which is/are
created in the section
BGM routing, page 79
. The configured
BGM routing can be used on the call station Music screen for
these specific selected Zone(s). A maximum of four music
sources can be assigned to one Zone and will be shown in
the display.
> and < Buttons Using the > and < buttons, a BGM routing channel can be
selected (left area box) and added or removed from the
assigned BGM routing channel (right area box).
Depending of the selected Function, different parameters could be selected, entered,
added/removed. See
Assigning a function, page 85
for descriptions.
Submit Button Click the Submit button to store the changes. Note that the
changes are not permanent and active until the configuration
is saved. See
Save configuration, page 102
.
Configure buttons
See
Assigning a function, page 85
for functions and
Assigning an operation, page 84
for
operations available for the call station (extension) buttons.
Each of the buttons listed and can be individual configured. To do so:
1. Select the Operation from the dropdown list.
2. Select, enter and/or add/remove the parameters belonging to the selected Function.
3. Click the Submit button to store the settings. See also
Save configuration, page 102
.
Recorded messages
Recorded messages selection is only visible/possible if this function is enabled in
Call station,
page 59
.
1. Click the + of the Recorded messages row.
2. Select the call definition:
– Note: Do not select call definition with Live speech set to "Yes".
3. Click the Submit button to store the settings. See also
Save configuration, page 102
.
To Next Page
Loading...
