Bosch SOLUTION 6000 - User Name;Password

Solution 6000  Installation Manual  Comms Programming
9-22
Bosch Security Systems 07/14 BLCC610I
1) Press [MENU] + [5] + [6] + [8]. The keypad will
prompt you to select which option that you want to
program.
SIA IP Account
SIA IP Account Prefix
SIA IP Receiver Prefix
Press
 OK or MENU
2) Highlight the option required, then press [OK] to
select.
Rr1 Dest 1
Rr2 Dest 2
Exit
Press
 OK or MENU
3) Highlight the destination that you want to
program, then press [OK] to select.
SIA IP Account Rr1
Press 
 OK to SAVE
4) Use the numeric keys [0] to [9] to program the
parameter, then press [OK] to save and exit or press
[MENU] to exit without saving.
Comms > IP Reporting >
User Name/Password

MENU 5-6-9
Username
1 Digits 16
Password
1 Digits 16
1) Press [MENU] + [5] + [6] + [9]. The keypad will
prompt you to select which option to program
(username or password) that you want to program.
Username
Password
Exit
Press
 OK or MENU
2) Highlight the option required, then press [OK] to
select.
Rt1 Dest 1
Rt2 Dest 2
Exit
Press
 OK or MENU
3) Highlight the destination that you want to
program, then press [OK] to select.
Username Rr1
Press 
 OK to SAVE
4) Use the [0] to [9] and [] and [] keys to program
the parameter, then press [OK] to save and exit or
press [MENU] to exit without saving.
Comms > IP Remote Access >
IP Address

-

MENU 5-7-0
Installer
1 Digits 12
0 0 0 0 0 0 0 0 0 0 0 0
User
1 Digits 12
0 0 0 0 0 0 0 0 0 0 0 0
This menu allows the installer or master user the ability to
program the Solution Link IP address.
1) Press [MENU] + [5] + [7] + [0]. The keypad will
prompt you to enter which Solution Link IP address
(IP 1 = Installer or IP 2 = User) that you want to
program.
Installer
User
Exit
Press
 OK or MENU
The installer can now select either the installer
Solution Link IP address or the user Solution Link IP
address by using the up and down arrow keys. If the
Master user programs this menu, the keyapd will only
display the option to program the user IP address:
2) Select the which IP address that you want to
change (installer or user, then press [OK] to enter.
3) The keypad will display the first six digits of the
Solution Link IP address.
RAS IP Address
000000000000
Press  OK to SAVE
4) Use the numeric keys [0] to [9] + [←] and [→] keys
to program the IP Address, then press [OK] to save
and exit or press [MENU] to exit without saving.