Solution 6000
Installation Manual Device Programming
10-15
Bosch Security Systems 07/14 BLCC610I
Devices > GSM/GPRS Module >
SMS Control
-
MENU 6-5-6
Phone 1
1 Digits 16
Phone 2
1 Digits 16
Phone 3
1 Digits 16
Phone 4
1 Digits 16
Phone 5
1 Digits 16
Phone 6
1 Digits 16
Phone 7
1 Digits 16
Phone 8
1 Digits 16
Phone 9
1 Digits 16
Phone 10
1 Digits 16
(GSM MODULE REQUIRED) The SMS control table allows
you to program up to 10 telphone numbers that the
control panel will automatically identify when you send
SMS commands to operate the control panel.
1) Enter [MENU] + [6] + [5] + [6]. The keypad will
display the following:
Phone 1=
Phone 2=
Phone 3=
Press OK or MENU
2) Highlight the telephone number that you want to
restrict for SMS control, then press [OK] to select.
SMS Control Phone 1
Press 0-9 OK to SAVE
3) Using the numeric keys, enter the telephone
number that you wish to program.
4) Press [OK] to save and return to the restrict SMS
control table, otherwise press [MENU] to exit
without saving.
Devices > Ethernet Module >
Module IP Address
MENU 6-6-0
1 Digits 12
0 0 0 0 0 0 0 0 0 0 0 0
This is the IP address of the TCP/IP module on the
customer’s internal local area network.
1) Press [MENU] + [6] + [6] + [0]. The keypad will
display the current IP address.
Module IP Address
000000000000
Press 0-9 OK to SAVE
2) Use the numeric keys [0] to [9] + [←] and [→] keys
to program the IP Address, then press [OK] to save
and exit or press [MENU] to exit without saving.
Devices > Ethernet Module >
Subnet Mask
MENU 6-6-1
1 Digits 12
0 0 0 0 0 0 0 0 0 0 0 0
The can be found by running IPCONFIG on a PC
connected to the clients network. Typical subnet mask is
255.255.255.0.
1) Press [MENU] + [6] + [6] + [1]. The keypad will
display the current subnet mask.
Subnet Mask
000000000000
Press 0-9 OK to SAVE
2) Use the numeric keys [0] to [9] + [←] and [→] keys
to program the 12 digit subnet mask number, then
press [OK] to save and exit or press [MENU] to exit
without saving.
To Next Page
Loading...
Need help?
General
