Solution 6000
Installation Manual Access Programming
5-4
Bosch Security Systems 07/14 BLCC610I
Access > PIN Codes >
Add PIN
-
MENU 1-1-2
This menu allows the installer or master users the ability
to add a PIN to another user. A master user can only add a
PIN for users that have been assigned to the same area(s).
1) Press [MENU] + [1] + [1] + [2] and use the up and
down arrows to highlight the user in the list then
press [OK]. The system will only list users that can
be added.
Ur2 Debbie Smith
Ur3 User 3 Name
Ur4 User 4 Name
Press
OK or MENU
2) Enter the new PIN, then press [OK] to save.
Enter New PIN For Ur2
Debbie Smith
Press OK or MENU
Access > PIN Codes >
Delete PIN
-
MENU 1-1-3
This menu allows the installer or master users the ability to
delete another users PIN. A master user can only delete a
PIN for users that have been assigned to the same area(s).
The installer and master user cannot delete their own PIN.
1) Press [MENU] + [1] + [1] + [3] and use the up and
down arrows to highlight the user in the list then
press [OK]. The system will only list users that can
be deleted.
Ur1 John Smith
Ur2 Debbie Smith
Ur3 User 3 Name
Press
OK or MENU
2) Press [OK] to delete the PIN or press [MENU] to
cancel.
Press OK To Delete PIN
For Ur2
Debbie Smith
Press OK or MENU
Access > PIN Codes >
View PIN
MENU 1-1-4
This menu allows the installer to view and verify the PIN
for any user.
1) Press [MENU] + [1] + [1] + [4] and use the up and
down arrows to highlight the user in the list, then
press [OK].
Ur1 John Smith
Ur2 Debbie Smith
Ur3 User 3 Name
Press
OK or MENU
2) The keypad will display the current PIN of the user
selected.
View PIN Ur1
2580
Press OK to SAVE
3) Press [OK] to save and exit or press [MENU] to exit
without saving.
USER TOKENS
This section outlines how to add and delete tokens. Users
1 to 255 can have a token assigned. Tokens provide an
alternate method for users to turn the system on and off
or to operate a door strike.
A token is a plastic card that has a unique ID number. Each
user can be assigned a PIN as well as a token for greater
flexibility.
A token can be presented to a keypad with a built in
reader or to an external LAN reader module to operate the
system. Tokens will follow all user settings.
Access > Token >
Add Token
-
MENU 1-2-0
This menu allows the installer or master user to assign a
token ID to each user. Only one token can be assigned to
each user. To change a token for an existing user you will
need to first delete the old token before you add the new
one. See MENU 1-2-1 — Delete Token
1) Enter [MENU] + [1] + [2] + [0] and use the up and
down arrows to highlight the user in the list then
press [OK]. The keypad will only list users that dont
already have tokens assigned.
Ur1 John Smith
Ur2 Debbie Smith
Ur3 User 3 Name
Press
OK or MENU
To Next Page
Loading...
