Brady BMP 41 - Page 54

Formatting
Font
42
BMP
®
41 User’s Manual
Pre-Existing Data
To apply an attribute to previously entered text:
1. Hold Shift while pressing the left/right navigation keys to move the cursor across
the characters on which the attribute will take affect.
This highlights the data.
Note: Highlighting works on a line-by-line basis. You cannot highlight more than
one line at a time.
2. Press Font .
3. Choose the attribute, then choose ON.
4. Press Enter .
All highlighted text displays the attribute.
Note: To remove the highlighting from the characters, press any navigation key.
To remove an attribute that was previously applied to some text:
1. Hold Shift while pressing the left/right navigation keys to move the cursor across
the characters from which the attribute will be removed.
2. Press Font .
3. Choose the attribute, then choose OFF.
4. Press Enter .
The attribute is removed from the text.