14
MENU STRUCTURE / NAVIGATION
All status information is available in the
bottom line of the display. The desired
information can be selected by using d
u and will be displayed (e. g. care area,
drug long name, time/ VTBI remaining
drug concentration, total volume, infused
totals for PRIMary and SECondary) until
changed by user.
Display
Meaning
Set pressure level with l or r and con-
firm by pressing k.
Cancel to edit pressure by using c.
Pre-alarms are indicated by a message on
the display (e.g. “VTBI near end”), an
audible tone and a flashing yellow LED.
To confirm a pre-alarm press k.
Operating alarms stop the infusion, an
audible tone sounds and the red LED
flashes. Confirm alarm by pressing k.
Confirming does not provide an acoustic
feedback.
This prompt appears if a user tries to edit
or change a parameter by pressing l
when that parameter is unable to be
changed.
Press and hold o for 3 sec to turn pump
off. A white bar stretches from left to right
and counts down the 3 sec.
The IV line must be removed to power the
pump off. Pump will go into stand-by if
the IV line is not removed.
To Next Page
Loading...
