41
Chapter 1
OPERATION
• Insert new lV line per Chapter 1.1. Close the pump door and open the roller clamp.
•
If prompted, prime the pump with u. Then press d to proceed when priming is
complete.
•
Connect IV line to patient and check the parameters with t.
•
Start the infusion by pressing sf.
Note: A new infusion can be started at any time during a stopped infusion. Press c
and respond yes to prompt "Exit and clear infusion". Note prompt will indicate if
PRIM, SEC or both will be cleared depending on current pump mode and infusion
status. B. Braun landing page will be displayed.
1.13 End of Infusion
• Press sf to stop the infusion. The green LED goes out. Close the roller clamp
and disconnect the line from the patient.
Remove emergency aperture cover.
Turn crank inside aperture to open the
door.
Turn crank to remove emergency
aperture cover.
To Next Page
Loading...
