INFUSOMAT SPACE® OVERVIEW
INFUSOMAT® SPACE OVERVIEW
3
Follow on screen prompts using arrow keys to navigate
menus, select parameters, change values and respond to
on screen prompts.
Press to clear values in
programming screens or to
go back one screen.
Press to Start/Stop
infusion.
Press to initiate auto-programming
orders when prompted.
Press to select and/or confirm
values/settings/alarms/messages.
q
c
k
m
Port P3 for future options
Cover of Battery Compartment
Before changing the battery, always disconnect the pump from the patient and switch the device off.
To remove the battery cover, push the button below the battery compartment with the point of a pen and pull the
cover away from the device. Slide the green locking mechanism on the back of the battery up and take out the battery
pack for repalcement.
A crank key used to open the pump door, which is stuck closed, is attached to the inside of the battery compartment
cover (for more information see subchapter 1.12).
Press to
initiate
bolus.
Press to turn
pump on/off
and initiate
stand by
mode.
Port P2 for power supply, SpaceStation, combi lead
and additional accessory leads (staff call, service plug)
Yellow LED: Pre-alarm, reminder alarm
Green or Red LED: or
Green LED: Infusing
Red LED: Operating or Device Alarm
Press to
open the
pump door.
x
onB
Sf
Blue LED: Initiating connection to wireless
battery or SpaceStation
To Next Page
Loading...
Need help?
General
